Stock Number: 2-18-UEATT-78
Make: Misc
Model: CARRIAGE


Stock Number: 2-18-UEATT-71
Make: Misc
Model: CARRIAGE


Stock Number: EQU005204
Make: Genie
Model: GTH844
Year: 2011


Stock Number: 301411
Make: Capacity
Model: TJ7000
Year: 2006


Stock Number: 2-18-UEF44
Make: Misc
Model: FORKS


Stock Number: 2-17-305553C
Make: Bobcat
Model: S130
Year: 2008


Stock Number: 231772
Make: Tico
Model: ProSpotter
Year: 2014


Stock Number: 1-16-600014
Make: Terex-Comedil
Model: CTT182-8 TS21
Year: 2015


Stock Number: EQU005629
Make: Hyster
Model: S50FT
Year: 2013


Stock Number: 208396
Make: CAT
Model: P6000-LE
Year: 2014


Stock Number: EQU000653
Make: CAT
Model: 2ET3000
Year: 2011


Stock Number: 212521
Make: JLG
Model: 1932RS
Year: 2014


 
Daewoo Propane Forklifts

Daewoo Propane Forklifts

Change a Propane Tank
Propane powered forklifts are commonly used in warehouses. The forklift is made with the propane tank mounted at the back of the operator. The tanks, that look much like beer kegs, have to be replaced from time to time because they have a limited lifespan. Drivers of forklifts should use care when handling propane tanks. Compressed gases are dangerous, particularly since the gas is flammable. Always use caution when removing and replacing propane tank to avoid injury.

1 To change a propane tank, first stop the lift truck and leave the engine running, and turn off the valve on the tank. Let the forklift run until the engine dies. This process burns off the gas inside the transfer hose which connects the tank and the engine. Before taking the next steps, put on the correct safety equipment, like insulated gloves made of either neoprene or leather. It is vital for you to protect your skin from touching the compressed gas, which is very cold.
2 The hose of the tank needs to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, reattach the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 You can check for leaks by applying soapy water to the valve and slightly opening it. Leaking gas would cause bubbles to foam around the value. If this occurs, inspect the connection hose at the nut and the valve area. Re-tighten the connecting nut if you detect any leaks around the area of the valve, and then perform the leak inspection procedure again. Persistent leaks mean that both the nut and connecting hose should be replaced. Nonetheless, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. After that you can start the lift truck and continue operating.

  • Hyster Outdoor Forklift
    Unisource - For over 90 brands of material handling machinery in addition to more than 4.8 million replacement parts and accessories, ... More
  • Mitsubishi Big Forklifts
    Lift truck operators are normally on the trucks more than 7 out of 8 hours per day in several forklift corporations. Operators will be ... More
  • Potain Construction Cranes
    Potain is a world leader in the industry of construction cranes. This is a specific kind which belongs to Manitowoc. They specify in ... More
  • Nissan Stand Up Forklift
    It is totally different to use a stand-up lift truck compared to a sit-down unit. The way you transport and lift cargo along with your ... More
  • Snorkel Boom Lifts
    Back during the year 1946, Wally Johnson began to create the markets for the scaffold towers and aerial work platforms all by himself. ... More