In nearly all situations, most individuals spend quite a lot of money buying their forklift. Hence, it is extremely important to take proper care of it in order to protect your investment well into the long run. It is really a good idea to know the procedures that are undertaken in the care and maintenance of this piece of machinery.
One of the best ways to tell how good the engine is running is by starting the lift truck up and listening carefully to see how it runs. For example, if there are any knocks or misses, the machine is defective and this must raise some concerns. In addition listen carefully for any squealing noise which come from the belts as these noises will provide you with a lot of information.
Several of the main parts needing attention during maintenance consist of the safety warning devices, gauges, horn, the overhead guard and the lights. Any faulty components or burnt out light bulbs have to be replaced as soon as they are noticed. It is also vital to inspect the wiring.
The battery compartment terminals should be cleaned when the above components have been inspected thoroughly. If the terminals are not clean, be sure to clean them properly. Each battery cell needs to be checked so as to make certain that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machine and after that change the filters. The fuel filters, hydraulic filter and the transmission filter have to be replaced regularly. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change is finished and the filters have been replaced, a visual inspection of the drive axle needs to be carried out. If there is a grease fitting on the axle make sure to apply some grease. Check the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. After that, inspect each and every other part of the machine including the wheels. If any kind of issue or fault is detected, be certain to deal with it immediately in order to make certain the equipment is running at its safest and optimum levels.